FIXIF Crate-Series
Coolers for Boats
Engineered for salt, spray and a deck that never stops moving.
A boat cooler has to mount fast, release faster and survive UV and corrosion that destroy lesser gear. FIXIF rotomolded crates lock to a low-profile magnetic base plate on your deck — no straps to fumble in chop, no brackets to re-drill every season.
Recommended
Why it works on a boat
The magnetic base plate holds the crate through chop and self-aligns when you drop it back on. Lift it off in one motion to refill, rinse or bail.
FIXLOCK™ aluminium buckles do not seize in salt the way plastic latches do, and there is no rubber to perish in UV.
FIXWATER™ certification means the crate doubles as drinking-water storage, and the FIXSEAT™ lid gives crew a place to sit. On a small boat that is real cockpit space recovered.
Sizing for boats
Day boats and tenders under 6 m: Pod 24 — a day of drinks and bait without eating cockpit space.
Cruising and sailing boats 6–10 m: Crate 36 — three to four days of food and drink for two.
Larger boats and charter: Trunk 51 — week-long passages with room for fresh produce.
Installation on deck
Through-bolt the base plate to teak, GRP or aluminium with marine-grade fasteners for a permanent install, or use 3M VHB tape on smooth gel coat for a non-destructive mount. Fit several plates and move the same crate between cockpit, foredeck and tender.
Pairs well with
Questions
Will the magnets corrode in salt water?
The high-pull magnets are sealed inside the rotomolded body and the base plate is sealed stainless. No magnetic surface is exposed. A fresh-water rinse is all the maintenance required.
Can I still use tie-down straps?
Yes. The FIXMODULAR™ chambers accept tie-down straps for extreme conditions or as a backup to the magnetic mount.
Does it scratch teak or gel coat?
The base plate sits between cooler and deck with a soft underlayer, so the crate never touches the deck surface directly.